Foam Brick Wall Panel Installation

Stone Ten™ Foam Brick Wall Panels are easy to install. The back of the brick panels have a self adhesive peel and stick feature making installation effortless. Stone Ten™ faux brick sticks to any smooth surface, allowing you to upgrade your space at a low cost.

Can't find the right color to match your walls? Our white brick panels can be painted to complement any space. The foam brick panels easily cut to size to create any look you want!

Stone Ten™ Foam Brick Panels are great in kitchens, bedrooms, office spaces, nurseries, play areas, and more! Don't let boring wallpaper ruin your artistic flare. Easily upgrade any space with Stone Ten™ Foam Brick Wall Panels.

Step 1: Measure the area you want to place the panels

Step 2: Wipe down your wall to remove any dirt and debris.

Step 3: Cut the panels to fit your measured area.

Step 4: Peel off the back of the wall panel.

Step 5: Place the panel on the wall sticky side down.

3D WALL PANEL INSTALLATION

Wall Surface Preparation

Repair any damaged surfaces on the wall where you plan to install the 3D Wall Panels and ensure that the wall is flat, clean, and dry.

3D Wall Panel Preparation

Allow the 3D Wall Panels to adapt to the humidity in the room where they are going to be installed by unboxing them and leaving them for 24 hours.

Design Preparation

Measure the wall that you are doing the installation on and plan your design. For a symmetrical installation, the first panels should be installed from the center of the wall. Using a measuring tape, find the center of the wall. Draw a horizontal line and vertical line in the center of the wall using a level to use as a guide during installation.

3D Wall Panel Installation

Use the level lines marked on the wall as a guide for your installation. Use glue / construction adhesive to apply the panels to the wall. Wipe away any excess glue with a dry towel. Make sure that each panel is level as you install them before they dry.

Putty / Filler

Once all of the panels have been installed, the seams can be filled with putty/filler and then sanded for a flawless appearance.

Painting / Finishing (Optional - Recommended for best results)

Make sure that all dust has been removed from the face of the panels before painting. To paint the panels start with one coat of high quality primer followed by 1 to 2 coats of high quality water based paint. Paint and primer in one can also be used.