Foam Brick Wall Panel Installation
Step 1: Measure the area you want to place the panels
Step 2: Wipe down your wall to remove any dirt and debris.
Step 3: Cut the panels to fit your measured area.
Step 4: Peel off the back of the wall panel.
Step 5: Place the panel on the wall sticky side down.
3D WALL PANEL INSTALLATION
Wall Surface Preparation
Repair any damaged surfaces on the wall where you plan to install the 3D Wall Panels and ensure that the wall is flat, clean, and dry.
3D Wall Panel Preparation
Allow the 3D Wall Panels to adapt to the humidity in the room where they are going to be installed by unboxing them and leaving them for 24 hours.
Measure the wall that you are doing the installation on and plan your design. For a symmetrical installation, the first panels should be installed from the center of the wall. Using a measuring tape, find the center of the wall. Draw a horizontal line and vertical line in the center of the wall using a level to use as a guide during installation.
3D Wall Panel Installation
Use the level lines marked on the wall as a guide for your installation. Use glue / construction adhesive to apply the panels to the wall. Wipe away any excess glue with a dry towel. Make sure that each panel is level as you install them before they dry.
Putty / Filler
Once all of the panels have been installed, the seams can be filled with putty/filler and then sanded for a flawless appearance.
Painting / Finishing (Optional - Recommended for best results)
Make sure that all dust has been removed from the face of the panels before painting. To paint the panels start with one coat of high quality primer followed by 1 to 2 coats of high quality water based paint. Paint and primer in one can also be used.